Download our Active Magnetic speed switch spec sheet:- Frequency range from 3 Hz to 10 kHz
- Signal Output: 0 - 10V; 0 - 5V(TTL); or 0 - Vsupply Open Collector, NPN or PNP
- Temperature Range: -40 to 120° C (-40 to 250° F) or -40 to 140° C (-40 to 284° F);
- Most popular thread sizes
- Air Gap: .030" (8 mm) typical to .5" max; (target mass and velocity dependent)
- Standard Shell: 303 Stainless
Specialized active magnetic speed transducers available: dual output; intrinsically safe to Zone 0; additional output for temperature; and hermetically-sealed and sanitary to NEMA 6, IP65 and IP67
Active Magnetic Speed Transducers
Our active VRS magnetic speed transducer has an integrated signal converter. The active magnetic transducer's solid state electronics deliver a digital output signal due to the transducer's coil getting triggered by a passing metal target. The digital output is read by computers, meters or speed governing instruments.
Our active VR speed transducers are found across the globe in the oil terminals, high-pressure pipeline installations, electric motors and applications with tough environments such as in mining trucks.
The benefits of the active magnetic speed transducer's internal pre-amp are: logic-level, signal amplitude output, improved signal-to-noise ratio, handles a wide spectrum of frequencies, and a greater air gap between the transducer and target. Internal temperature probes are also available for a two output model. A variety of temperature detection positions and probes are available.
OTHER PRODUCTS:
For high temperature applications demanding a remotely mounted magnetic speed transducer with a separate signal conditioner, refer to our magnetic speed transducers and pre-amps.